Skycolor flatbed uv printer group is a professional manufacturer of flatbed uv printers. The specific methods for cleaning Skycolor flatbed uv printer head are as follows.

Operation steps: To clean Skycolor flatbed uv printer head, you need distilled water, a lint-free scrubbing cloth and a plate.

1.Soak the cloth with distilled water

2.Use a damp cloth to gently suck (do not wipe) the nozzles at the bottom of Skycolor flatbed uv printer head, and repeat the process 3 to 5 times for all nozzles to be cleaned. A clean cloth should be used for each nozzle to avoid mixing of colors. Test Skycolor flatbed uv printer head to see if the nozzle is blocked. If clogging still exists, heat the distilled water slightly and place a small amount on the plate. (When placing Skycolor flatbed uv printer head on the plate, the water surface should not be higher than 2cm above the bottom because water may leak behind the core.) Stand Skycolor flatbed uv printer head upright in warm water. Wait for 30 seconds, and then test after drying Skycolor flatbed uv printer head. Each nozzle must be cleaned with clean water. In addition, an ultrasonic cleaner can also be used to clean Skycolor flatbed uv printer head. To clean the chip, you need alcohol and a cotton swab or a lint-free scrub cloth.

3. Turn off the power of Skycolor flatbed uv printer. Soak the cloth with wine clear. Gently scrub the chip behind Skycolor flatbed uv printe to remove dirt or ink. Repeat this process for each nozzle, making sure that each nozzle is scrubbed with a clean part of a cloth or a clean cotton swab. Take Skycolor flatbed uv printer head out of the trolley frame and use a clean wet cotton swab or damp cotton cloth to gently scrub the contact strip on the trolley frame. After cleaning, install Skycolor flatbed uv printer head to make sure they are properly installed in place.