Skycolor UV flatbed printers are also known as universal printers. In this era of rapid economic development, the emergence of universals has brought huge room for improvement in all industries. Its wide range of use can be called universals, so it is directly called by people-universal printer.
Basically: glass, tiles, acrylic, wood, metal, leather, advertising materials all need it.
In fact, its omnipotence is just that compared with traditional printing equipment, the applicable materials are more abundant, the printing speed is faster, the accuracy is higher, the operation steps are simple, and many labor costs are saved.
It should be noted that, in the following three cases, please use the Skycolor Ricoh Gen5 UV printer carefully to minimize the loss.
1.Curved material with excessive radian
During the operation of the machine, if the height difference of the printed materials is more than 1 cm, the universal printer cannot complete full-frame printing, because the inkjet pitch is too large, which will cause unclear patterns and ink scattering.
2.Material surface is too reflective
When the universal printer is working, after the ink is sprayed, the UV lamp needs to be irradiated with UV rays to dry, which can achieve immediate effects such as print and dry. Ultraviolet rays will be reflected on the nozzle, causing the ink to be dried before the ink is ejected. This will easily cause the nozzle to be blocked and the nozzle will be scrapped.
3.High temperature, strong acid, strong alkali, etc.
UV inks used by UV universal printers encounter high temperatures, strong acids, and strong alkalis, which can reduce the adhesion of the inks, causing the patterns to fall off and deform.
Therefore, in the daily production of UV universal printers, we must pay attention to the above three situations, try not to print in the above three situations, so as to avoid damage to the universal printer.
In addition, there are several behaviors that endanger the printer and should be avoided during use.
1. Brute force adjustment nozzle
Use external force to adjust the nozzle position irregularly. Do not use brute force whether you are replacing or fine-tuning the printhead. Please treat the printhead carefully according to the specifications.
2. Switch the circuit at will
Install and remove the UV flatbed printer circuit at will without turning off the power to turn on the light and cut off the main power. This behavior will damage the service life of each system and endanger the sprinkler.
3.Immersion cleaning head
Although the cleaning liquid can be soaked in the cleaning liquid for a long time, the stain can be more effectively cleared. However, the cleaning liquid is corrosive. If the time exceeds 48 hours, it will affect the nozzle nozzle itself. Therefore, it is generally only necessary to take an appropriate amount to be introduced into the nozzle for cleaning.
4.Use poor quality ink
Fill in different batches of ink at will, or use inferior ink and cleaning solution. The mixing of two different configurations of ink will change the color and quality of the ink, but the ink that is not good enough will affect the printing effect and block the nozzle, which will damage the life of the nozzle.